Mitsubishi Electric MELSEC-Q Series - Page 191

189
CHAPTER 6 PARAMETER SETTING
6
6.3 Network Range Assignment 6.3.1 LB/LW settings
(b) When extending the send range of station No.1 to 1024 points without changing the
assignment shown in (a) ("LB/LW Setting(2)")
When any of the station send ranges in LB/LW has been changed, check the link refresh range of each station. ( Page
204, Section 6.5)
Control station
No.1
Normal station
No.2
LB0 to LB1FF
LB200 to LB3FF
LB400 to LB5FF
LB600 to LB7FF
LB800 to LB9FF
LB7FFF
Network
range assignment
LB/LW setting
Normal station
No.3
Normal station
No.4
Station No.1
Station No.1 Station No.1 Station No.1
Station No.1
No.2
No.3
No.4
No.1 send range
No.1 send range
No.2
No.3
No.4
Station No.1
No.2 send range
No.3
No.4
Station No.1
No.2
No.3 send range
No.3 send range
No.4
Station No.1
No.2
No.3
No.4 send range
Link relay (LB)
LW0 to LW1FF
LW200 to LW3FF
LW400 to LW5FF
LW600 to LW7FF
LW800 to LW9FF
LW1FFFF
Station No.1
Station No.1 Station No.1 Station No.1
Station No.1
No.2
No.3
No.4
No.1 send range
No.1 send range
No.2
No.3
No.4
Station No.1
No.2 send range
No.3
No.4
Station No.1
No.2
No.4
Station No.1
No.2
No.3
No.4 send range
Link register (LW)