Mitsubishi Electric MELSEC-Q Series - Page 235

233
CHAPTER 6 PARAMETER SETTING
6
6.8 Interlink Transmission Parameters
*1 LB is set in 16-point units (Start: 0
H
to End: F
H
), and LW is set in 1-point units.
Item Description
Assignment Method
Select a link device assignment method.
• Points/Start: Enter link device points and start I/O numbers.
• Start/End: Enter the start and end numbers of the link devices.
Transfer from/Transfer to
Displays the module numbers and network types of the transfer source and
transfer target.
LB
Transfer from Points, Start, End
Set the LB ranges of the transfer source.
*1
(Setting range: 0000
H
to 7FFF
H
, Default: None)
Transfer to Points, Start, End
Set the start numbers of the transfer target LB.
*1
(Setting range: 0000
H
to 7FFF
H
, Default: None)
LW
Transfer from Points, Start, End
Set the LW ranges of the transfer source.
*1
(Setting range: 0000
H
to 1FFFF
H
, Default: None)
Transfer to Points, Start, End
Set the start numbers of the transfer target LW.
*1
(Setting range: 0000
H
to 1FFFF
H
, Default: None)