243
CHAPTER 6 PARAMETER SETTING
6
6.9 Routing Parameters
(3) Routing parameter setting example
The routing parameters for each station in the following system configuration are shown in this section.
Any station can transmit transient data to any other station.
(a) Routing parameters for each station of the network No.1
(b) Routing parameters for each station of the network No.2
(c) Routing parameters for each station of the network No.3
(d) Routing parameters of the relay station 1
(e) Routing parameters of the relay station 2
(4) Checking the routing parameter setting (communication test)
With a communication test in the programming tool, whether routing of transient transmission can be correctly
performed between the own station and a communication destination can be checked. ( Page 174, Section
5.7.1)
Verify that the routing parameter settings are correct.
Network No.1
1MP1 1NS2
1NS6 1NS5 1NS4 2MP1
1NS3
Network No.3
3NS2
3NS33NS4
3MP1
(Relay station 1)
2NS4 3NS5
(Relay station 2)
Network No.2
2NS2 2NS3
No setting is required for the relay station 1 (1N
S
4, 2M
P
1)
because data are transmitted via the own station.
No setting is required for the relay station 1 (1N
S
4, 2M
P
1)
because data are transmitted via the own station.
No setting is required for the relay station 2 (2N
S
4, 3N
S
5)
because data are transmitted via the own station.
No setting is required for the relay station 2 (2NS4, 3NS5)
because data are transmitted via the own station.
To Next Page
Loading...
