Mitsubishi Electric MELSEC-Q Series - Page 248

246
*2 Indicates base units on which the CC-Link IE Controller Network module is mounted.
(2) For safety CPUs
*1 Total number of link device points for the range set by refresh parameters and set in the network range assignment. Note
that the points assigned to reserved stations are excluded.
The values in this section are calculated on the basis that data are received from all stations during one sequence scan.
When the link scan is long or when the sequence scan is short, data from all stations may not be received within one
sequence scan.
If this occurs, the actual link refresh time is less than the calculated value shown in this section.
CPU type
KM1(×10
-3
)
KM2(×10
-3
) KM3(×10
-3
)
Main base
*2
Extension
base
*2
Main base
*2
Extension
base
*2
Basic model
QCPU
Q00JCPU 1300 0.67 1.50
——Q00CPU 1100 0.66 1.44
Q01CPU 900 0.61 1.42
High
Performance
model
QCPU
Q02CPU 300 0.48 1.20 0.60 1.32
Q02H/Q06H/Q12H/Q25HCPU 130 0.41 0.97 0.53 1.09
Process
CPU
Q02PH/Q06PH/Q12PH/Q25PHCPU 130 0.41 0.97 0.53 1.09
Redundant
CPU
Q12PRH/Q25PRHCPU 130 0.41 — 0.53 —
Universal
model
QCPU
Q00UJ/Q00U/Q01U 160 0.41 1.06 — —
Q02UCPU 160 0.41 1.06 0.39 0.39
Q03UD/Q03UDECPU 90 0.41 0.97 0.39 0.39
Q04UDH/Q04UDEH/Q06UDH/Q06U
DEH/Q10UDH/Q10UDEH/Q13UDH/
Q13UDEH/Q20UDH/Q20UDEH/Q26
UDH/Q26UDEH/Q50UDEH/Q100UD
EHCPU
90 0.41 0.97 0.33 0.33
Q03UDV/Q04UDV/Q06UDV/Q13UD
V/Q26UDVCPU
45 0.41 0.97 — —
T: Link refresh time on sending side
R: Link refresh time on receiving side
LB: Total number of actual link refresh points in LB
*1
LW: Total number of actual link refresh points in LW
*1
LX: Total number of actual link refresh points in LX
*1
LY: Total number of actual link refresh points in LY
*1
SB: SB points
SW: SW points
T, R
1.85
10
-3
[ms] 1000
LB LX LY SB
LW SW
16