Mitsubishi Electric MELSEC-Q Series - Page 279

277
CHAPTER 8 PROGRAMMING
8
8.1 Program Example of a Single Network System 8.1.3 Program example of cyclic transmission
(3) Program example
The following shows a program example.
(a) Program example of control station (No. 1)
(b) Program example of normal station (No. 2)
Communication
with normal
station (No.2)
When creating a cyclic communication program,
establish an interlock using Data link status of own station
(SB0049) and Cyclic transmission status (SW00B0).
Communication
with control
station (No.1)