Mitsubishi Electric MELSEC-Q Series - Page 295

293
CHAPTER 8 PROGRAMMING
8
8.2 Program Example of a Multi-network System 8.2.2 Setting and communication contents
(d) Routing parameters
Set routing parameters for the control station (1M
P
1) with the following system configuration.
1. Fill in the routing parameter sheet. ( Page 662, Appendix 5.7)
Ex.
Control station (1M
P
1)
2. Complete settings in the programming tool based on the contents filled in the parameter sheet.
• Routing parameter setting (Control station (1M
P
1))
CC-Link IE Controller
Network module
Control
station
1M
P 1
Control
station
2M P 1
Normal
station
1N S 2
Normal
station
2N
S 2
Network No.1 Network No.2
1
No.
Target
Network No.
Relay
Network No.
Relay
Station No.
"To go to network No.2, data passes through station No.2 of its own network No.1."
122
No setting is required for relay station (1N
S 2)
because data are transmitted via the station.
1
No.
Target
Network No.
Relay
Network No.
Relay
Station No.