320
(13)Checking normal (own) station No. setting status
The normal (own) station No. setting status can be checked not only by CC IE Control diagnostics but also with
the link special relay (SB) and link special register (SW). ( Page 526, Section 10.3)
(a) When station No. is set in Network parameters
1. After power-on, when a station No. is entered, Station No. setting status (own station) (SB0070) is
turned OFF.
2. The station No. of the own station is stored in Station No. (SW0042).
(b) When station No. is set with a UINI instruction
1. After power-on, because no station No. is set, Station No. setting status (own station) (SB0070) is
turned ON.
2. The absence of the station No. setting is stored in Station No. (SW0042).
3. When a station No. is set up by execution of the UINI instruction, Station No. setting status (own
station) (SB0070) is turned OFF.
4. The station No. of the own station is stored in Station No. (SW0042).
(14)Dedicated instructions
The following link special relays (SB) and link special registers (SW) are used for dedicated instructions.
( Page 324, CHAPTER 9)
(a) READ/SREAD/WRITE/SWRITE/REQ/SEND instruction
Create an interlock with the following link special relay (SB) and link special register (SW) before executing an
instruction.
• Baton pass status (own station) (SB0047)
• Baton pass status of each station (SB00A0) (When all stations are specified)
• Baton pass status of each station (SB00A0 to SW00A7)
No. Description No. Description
— SW0042 Station No.
SB0070 Station No. setting status (own station) —
No. Description No. Description
SB0047 Baton pass status (own station) —
SB00A0 Baton pass status of each station
SW00A0
to
SW00A7
Baton pass status of each station
To Next Page
Loading...
