33
CHAPTER 1 OVERVIEW
1
1.1 Features
(8) Project data common to normal stations
For Universal model QCPUs, the station No. of a normal station (own station) can be set in the sequence
program.
*1
If there are any normal stations that can share the same sequence program and network parameters (except for
station No.), specifying their station numbers in the sequence program creates common project data for them,
allowing easy data management. ( Page 136, Section 4.6)
*1 For modules other than Universal model QCPUs, station No. cannot be set in sequence programs.
Station Nos. must be set with network parameters.
Station No. setting by
sequence program
Programming tool
Control
station
(No.1)
Normal
station
(No.2)
Normal
station
(No.3)
Normal
station
(No.6)
Normal
station
(No.5)
Normal
station
(No.4)
Station No. setting by
sequence program
Common project data can be created for
normal stations, resulting in easy management.
Station No. setting by
sequence program
Station No. setting by
sequence program
Station No. setting by
sequence program
For control
station
For normal
stations
For normal
stations
For normal
stations
For normal
stations
For normal
stations
For normal
stations
For control
station
To Next Page
Loading...
