Mitsubishi Electric MELSEC-Q Series - Page 363

361
CHAPTER 9 DEDICATED INSTRUCTIONS
9
9.5 JP/GP.WRITE (Data Write to Programmable Controllers on Other Stations)
(5) Program example
In this program example, when M112 turns ON, data in D750 to D753 of station No.2 (own station) are written to
D300 to D303 of station No.3 (target station).
If the own station is on a redundant system, the station numbers used for the redundant system in this case are
assumed to be No.1 and No.2.
(a) System configuration example
• When the own station is not on a redundant system
• When the own station is on a redundant system
CPU module
WRITE instruction
request source
(Own station)
WRITE instruction
request target
(Target station)
D750
D751
D752
D753
D300
D301
D302
D303
CC-Link IE
Controller
Network module
Channel 2
CPU module CC-Link IE
Controller
Network module
CPU module CC-Link IE
Controller
Network module
CPU module CC-Link IE
Controller
Network module
Network No.1
Station No.1 Station No.2
Station No.4 Station No.3
Network No.1
Channel 2
CPU module
CPU module
Station No.2 (Control system)Station No.1 (Standby system)
D750
D751
D752
D753
CPU module
CPU module
Station No.4
Station No.3
D300
D301
D302
D303
CC-Link IE
Controller
Network module
WRITE instruction
request source
(Own station)
CC-Link IE
Controller
Network module
CC-Link IE
Controller
Network module
WRITE instruction
request target
(Target station)
CC-Link IE
Controller
Network module