41
CHAPTER 2 SYSTEM CONFIGURATION
2
2.3 Applicable Systems
(3) Software package
Systems using the CC-Link IE Controller Network module and software package are shown below.
To use the CC-Link IE Controller Network module, the programming tool is required.
*1 Available functions differ depending on the version of the programming tool. ( Page 606, Appendix 3)
*2 When using a GX Developer Version earlier than 8.68W, please interpret the description of "MELSECNET/G" as "CC-
Link IE Controller Network".
System configuration
Programming tool version
*1
GX Developer GX Works2
Q00J/Q00/Q01CPU
Single CPU system
Version 8.68W or later
Refer to the GX Works2
Version 1 Operating Manual
(Common).
Multiple CPU system
Q02/Q02H/Q06H/Q12H/Q25HCPU
Single CPU system
Version 8.45X or later
*2
Multiple CPU system
Q02PH/Q06PH/Q12PH/Q25PHCPU
Single CPU system
Version 8.68W or later
Multiple CPU system
Q12PRH/Q25PRHCPU Redundant system Version 8.68W or later
Q00UJ/Q00U/Q01UCPU
Single CPU system
Version 8.76E or later
Multiple CPU system
Q02U/Q03UD/Q04UDH/Q06UDHCPU
Single CPU system
Version 8.48A or later
*2
Multiple CPU system
Q10UDH/Q20UDHCPU
Single CPU system
Version 8.76E or later
Multiple CPU system
Q13UDH/Q26UDHCPU
Single CPU system
Version 8.62Q or later
Multiple CPU system
Q03UDE/Q04UDEH/Q06UDEH/Q13UD
EH/Q26UDEHCPU
Single CPU system
Version 8.68W or later
Multiple CPU system
Q10UDEH/Q20UDEHCPU
Single CPU system
Version 8.76E or later
Multiple CPU system
QS001CPU Single CPU system Version 8.65T or later
CPU modules other than the above
Single CPU system
Not available
Multiple CPU system
To Next Page
Loading...
