455
CHAPTER 9 DEDICATED INSTRUCTIONS
9
9.15 Z(P).RSTOP (Remote STOP)
(e) RSTOP instruction execution timing
With Z.RSTOP, processing is executed one after another while the start contact is ON.
With ZP.RSTOP, processing is performed one time only when the start contact turns ON from OFF.
• When completed normally
1 scan
RSTOP
Sequence scan
Start contact
Own station CPU
Target station CPU
Remote STOP
CC-Link IE Controller
Network module
Network module
OFF
Completion device
(Device specified in (D1))
Completion status indication
device (Device of (D1)+1)
Sequence scan
Stopped
END0 END0
Channel 1
END0 END0 END0
END0 END
*1
*1 Several scans are taken until the sequence scan is stopped, depending on the system configuration, sequence scan time, etc.
0
To Next Page
Loading...
