473
CHAPTER 9 DEDICATED INSTRUCTIONS
9
9.17 Z(P).RTMWR (Clock Data Write to Programmable Controllers on Other Stations)
• When failed
(4) Error
When a link dedicated instruction failed, the error details can be confirmed by either of the following methods.
(a) With the programming tool
The error details can be checked in the CC IE Control diagnostics. ( Page 526, Section 10.3)
(b) Checking devices
Completion status indication device ((D2)+1) is turned ON, and an error code is stored in Send/receive
instruction processing result (SW0030 to SW0037).
Check the error and take corrective actions according to the error code. ( Page 511, Section 10.2)
No. Name
SW0030 Send/receive instruction (1) processing result
SW0031 Send/receive instruction (2) processing result
SW0032 Send/receive instruction (3) processing result
SW0033 Send/receive instruction (4) processing result
SW0034 Send/receive instruction (5) processing result
SW0035 Send/receive instruction (6) processing result
SW0036 Send/receive instruction (7) processing result
SW0037 Send/receive instruction (8) processing result
1 scan
RTMWR
Sequence scan
Start contact
Own station CPU
CC-Link IE Controller
Network module
Completion device
(Device specified in (D2))
Completion status indication
device (Device of (D2)+1)
Clock data
Error code
Clock data storage device
(Device specified in (D1))
Send/receive instruction (1)
processing result (SW0030)
END0 END0
Channel 1
Target station error
END0 END0 END0
To Next Page
Loading...
