51
CHAPTER 3 SPECIFICATIONS
3
3.2 Function Lists
(6) List of other functions
: Available, : Partially available, ×: N/A
*1 The area of LB/LW4000 or higher cannot be specified for interrupt conditions.
*2 CPU modules that can be used differ depending on the connection path. ( Page 107, Section 4.3.1)
1) Safety CPU
2) Basic model QCPU
3) High Performance model QCPU
4) Process CPU
5) Redundant CPU
6) Universal model QCPU
Function Description
CPU module
Reference
section
1) 2) 3) 4) 5) 6)
Interrupt request to CPU module
Interrupt conditions are checked every link scan,
and if the conditions are met, an interrupt is
requested to the CPU module to start the interrupt
program.
×
*1
Page 135,
Section 4.5
Station No. setting by sequence
program
For Universal model QCPUs, the station No. of a
normal station (own station) can be set in the
sequence program. (UINI instruction)
×××××
Page 136,
Section 4.6
Page 324,
CHAPTER 9
IP packet transfer function
Communications in a protocol, such as FTP and
HTTP, using the specified IP address of an
Ethernet device can be performed over CC-Link IE
Controller Network.
With this function, two networks of CC-Link IE
Controller Network and Ethernet are not required,
resulting in reduced wiring cost.
×××××
*2
Page 106,
Section 4.3
To Next Page
Loading...
