Mitsubishi Electric MELSEC-Q Series - Page 58

56
● Transient transmission error logs can be checked in "Logging" of the CC IE Control diagnostics. ( Page 533,
Section 10.3.3)
● Transient transmission error logs can be cleared by the following.
• Clearing error information in "Logging" of the CC IE Control diagnostics. ( Page 533, Section 10.3.3)
• Setting Clear transient transmission error counter (SB000A) to ON. ( Page 568, Appendix 1)
• Powering off and on the system or resetting the CPU module
● If a transient transmission error is detected at start of the CC-Link IE Controller Network module, the time of error
occurrence may be left blank.