620
(e) Other functions
Function Description
Reference
section
Station No. setting by sequence program
For Universal model QCPUs, the station No. of a normal station (own
station) can be set in the sequence program. (UINI instruction)
Page 136,
Section 4.6
Page 324,
CHAPTER 9
IP packet transfer function
Communications in a protocol, such as FTP and HTTP, using the specified
IP address of an Ethernet device can be performed over CC-Link IE
Controller Network.
With this function, two networks of CC-Link IE Controller Network and
Ethernet are not required, resulting in reduced wiring cost.
Page 106,
Section 4.3
To Next Page
Loading...
