Mitsubishi Electric MELSEC-Q Series - Page 639

637
APPENDICES
A
Appendix 4 Comparison Between CC-Link IE Controller Network and MELSECNET/H Appendix 4.4 Precautions for system replacement
(4) Replacing station-specific parameter data with refresh parameter data
The CC-Link IE Controller Network module does not have station-specific parameters.
Replace the station-specific parameter data of a MELSECNET/H module with the refresh parameter data of a
CC-Link IE Controller Network module.
Ex.
When network range assignment has been set by station-specific parameters as shown below
• Image of assignment by station-specific parameter
Move device of station No.1 (b). (B100 to B1FFB500 to B5FF)
Close up devices of station No.2 to No.5.
Parameter settings after the replacement are listed on the following page.
Station No.1(a)
Station No.2
Station No.3
Station No.4
Station No.5
Station No.1(b)
Link relay (B)
Link refresh
Link refresh
CPU module
0
FF
100
1FF
200
2FF
300
3FF
400
4FF
500
5FF
Station No.1(a)
Station No.2
Station No.3
Station No.4
Station No.5
Station No.1(b)
Station-specific parameter (LB)
MELSECNET/H module
0
FF
100
1FF
200
2FF
300
3FF
400
4FF
500
5FF
Station No.1(a)
Station No.1(b)
Station No.2
Station No.3
Station No.4
Station No.5
Network range assignment (LB)
0
1FF
200
2FF
300
3FF
400
4FF
500
5FF