85
CHAPTER 4 FUNCTIONS
4
4.1 Cyclic Transmission Function
4.1.9 Increase of send points by mounting multiple CC-Link IE Controller Network modules of the same
network No.
(1) Setting network parameters
Set the same network No. to multiple CC-Link IE Controller Network modules in the network setting.
The setting is explained using the following system configuration, where two CC-Link IE Controller Network
modules are mounted.
(a) Network setting
Configure the network setting as shown below.
(b) Network range assignment
Set each station's send range in LB/LW in "LB/LW Setting" of "Network Range Assignment" of the control
station. ( Page 185, Section 6.3.1)
The setting example indicates
this part of the configuration.
Control station
1M
P
1
Normal station
1N
S
2
Normal station
1N
S
3
Normal station
1N
S
4
Normal station
1N
S
5
Set the same network No.
Set a unique station number for each station.
The same station No. cannot be set to
multiple stations.
Set one station as the control station.
Multiple control stations cannot be configured.
To Next Page
Loading...
