Mitsubishi Electric QJ71GF11-T2 - Page 221

219
CHAPTER 9 CC-LINK IE FIELD NETWORK DIAGNOSTICS
9
9.3 Diagnostic Window
Selected Station Communication Status
Monitor
Displays status of the station selected in "Network Status".
Item Description
1)
2)
4)
6)
7)
8)
3)
5)
9)
6)
When a station where an error has
occurred is selected
When a station with no station No.
setting is selected
When a remote device station is selected
1)
Displays operating status.
: Normal operation
: Error (Data link is continued.) (yellow)
: Error (Data link is stopped.) (red)
2) Displays a mode.
3) Displays a MAC address.
4) Displays an IP address (only when it is set).
5)
Sets a station number for a slave station to which a station number has not been set.
This button is displayed only when a slave station meeting all the following conditions
has been selected in "Network Status".
• The slave station supports station number setting from the master station.
• A station number has not been set to the slave station.
*1
When a station set in "Network Configuration Settings" is added, the external device
connected to the slave station outputs data input from the master station,
simultaneously with configuration of the station number setting. Therefore, set the
CPU module to STOP or check that outputs from the external device will not cause a
problem beforehand.
6)
Click this button to check error details. Take corrective actions, following description
displayed in "Error Factor" and "Troubleshooting".