220
Selected Station Communication Status
Monitor
*1 For how to clear the station number set for a slave station in the CC-Link IE
Field Network diagnostics, refer to the manuals for modules used on slave
stations.
*2 To display the information of an extension module, a master/local module
with a serial number (first five digits) of 14102 or later is required.
Operation
Tes t
button
Performs a communication test. ( Page 79, Section 6.4.3)
button
Performs an IP communication test. ( Page 156, Section 8.3.3)
button
Performs a cable test. ( Page 78, Section 6.4.2)
button
Starts or stops cyclic transmission. ( Page 221, Section 9.4)
Information
Confirmation/
Set
button
Displays event history of a network. ( Page 223, Section 9.5)
button
Temporarily cancels a reservation for a slave station or reserves the slave station again.
( Page 225, Section 9.6)
button
Sets a slave station as a temporary error invalid station. ( Page 229, Section 9.7)
Selected
Station
Operation
button
Displays the System Monitor window. ( Page 426, Section 12.2)
button
Performs remote operations (RUN, STOP, and RESET operations) to the CPU module.
( Page 234, Section 9.8)
Item Description
7)
Displays the LED status of a module and communication status of PORT1 and
PORT2. ( Page 31, CHAPTER 2)
8)
Displays status of the cables connected to PORT1 and PORT2.
: Properly connected
: Error (cable disconnection)
: Error (other than cable disconnection)
9)
Displays the information of the extension module connected to the remote device
station.
*2
To Next Page
Loading...
