Motala MC2000 - SITE REQUIREMENTS AND TOOLS

To Next Page

To Previous Page

Threshold – Installation instruction

TABLE OF CONTENTS

1. GENERAL .................................................................................................................1

1.1 RELATED DOCUMENTS ................................................................................1

2. SAFETY .....................................................................................................................1

3. SITE REQUIREMENTS AND TOOLS ......................................................................2

3.1 SITE REQUIREMENTS ...................................................................................2

3.2 TOOLS.............................................................................................................2

3.3 CHECK DELIVERY .........................................................................................2

3.4 STANDARD SIZES ..........................................................................................2

4. FASTENERS USED IN THE INSTALLATION INSTRUCTION ................................2

5. INSTALLATION ........................................................................................................3

5.1 PREPARATION....................................................................................................3

5.1.1 FINISHED FLOOR ......................................................................................3

5.1.2 IF THE FLOOR IS NOT FINISHED. .................................................................3

5.2 FITTING THE THRESHOLD ....................................................................................4

5.2.1 MARKUP FOR POP RIVETS ........................................................................4

5.2.2 FIT THE OUTER PART TO THE INNER PART. .................................................4

5.2.3 WORKING POSITION .................................................................................5

5.2.4 FITTING THE INNER PART ..........................................................................5

6. APPROVALS AND VERSION HISTORY .................................................................6

1. GENERAL

This Threshold is special designed to fit on Motala Lifts. Follow this instruction carefully to

ensure an efficient and trouble-free installation.

Note! In this illustration the shaft door´s are left out to easier illustrate the steps of the

installation. Normaly all shaft door´s should be in place and closed, just the door where the

threshold is being installed should be opened.

Note! This threshold is to be fitted only when the gap between the lift and the finished floor is

maximum 30 mm. Otherwise a special solution must be provided.

1.1 RELATED DOCUMENTS

 This instruction is to be used with the MC2000 installation instruction.

 The principle of the installation method of the threshold can also be used to install the

thresholds on elevator M6000, M6000 LS and ProSpace, then the instruction is to be

used with respectively elevator installation instruction.

2. SAFETY

Personal safety precautions for fitters.

Always use Personal Protective Equipment (PPE). Always use Head protection, Eye protection,

Foot protection, Hand protection, Protective clothing, Face shield and Safety harness.

Follow the safety precautions in the MC2000, M6000, M6000 LS or ProSpace installation

instruction depending on which elevator the threshold is installed on.