Motala MC2000 - Test the flip chair

MOTALA MC2000 – Flip chair on the platform
Instruction
© 2012 Motalahissar AB 5 (6) IQ56-06
Rev: -
Mount the flip chair
1. You have to tension the flip chair
apart to be able to fit the screws,
use 6x 101725. It is easier to be
two persons doing this phase of
the installation.
Test the flip chair
1. Test the flip chair by pull it out
and push all the way to the floor.
2. Then test that the gas spring
brings the flip chair up again.
3. In the upper retracted position
the flip chair must be hold in
position by the magnets.