MC2000 – Assembly Instruction Manual
30
Connecting control panel wiring
Connecting drive command box
Safety
1. Connect the cables in the control panel ac-
cording to the electrical diagram.
• Do not cut the cables too short.
• Unload the cables with cable tie.
• Import
ant! Make sure there is no lead
connected to terminal input 15 on the
PLC! Impulse function!
Use the approved drive command box from
Motal
a Hissar (with emergency stop).
Note! For your own safety and that of other
pers
ons, disconnect the control voltage for
the call buttons, connected to terminals X1/
47 and X1/48. See the electrical drawings.
1. Connect the emergency stop to block X1/3
and X1/
10 in the controlpanel. Important!
This is the same terminals where the
platform safety contacts will be con-
nected later. The command box shall be
di
sconnected before connect the plat-
form safety leads.
2. Connect the lift drive wires. Connect the
sup
ply to terminal X1/24V, upwards drive to
X1/42 and downwards drive to X1/41. See
the electrical drawings.
x
To Next Page
Loading...