MC2000 – Assembly Instruction Manual
32
Commencing with drive command box
1. The safety circuit must be whole in order to
drive, i.e. stop circuit, door circuit, lock cir-
cuit etc.
2. Switch on the supply voltage.
3. Check that the slides of the platform goes
i
n the right direction in relation to the con-
tactors. If they go in the wrong direction,
cha
nge motor phase.
The lift will only go down after the current
has been discone
cted!
The lift has PLC control, so you can only drive
to
landing 0 the first time, in order to reset the
PLC program after the current has been dis-
connected. You may need to adjust floor 0 limit
swi
tch now.
Chain jointing rod
1. With the drive command box, drive the
slides almost to the top so that the chain
ends are reachable from landing 0.
2. With a big screw driver, press the lower
end
of the chain upwards. Measure the de-
sirable length of the jointing rod.
3. Measure and drill a new hole (diameter 6.0
mm) in t
he jointing rod. Cut and bevel the
ends.
4. Fit the jointing rod with connecting links.
5. Perform the same procedure on the other
cha
in.
6. Drive the slides down.
To Next Page
Loading...