43
MC2000 – Assembly Instruction Manual 2011-10
Lock arms
Highspeed contact and magnet
5. Run the lift to an exact position on each
floor and fit the lock arm. When the lift is on
a certain floor, the roller of the lock arm
should be in the centre of the ramp. Note!
There is an exception for the bottom and
top floors: there, the lock arm should be fit-
ted so that, when the lift reaches the floor,
the roller has just reached the flat part of
the ramp.
6. Adjust the length of the lock wires by cut-
ting the outer cover so that it reaches the
lock arm. Let the inner cover run a short
distance through the lock arm sleeve. Pull it
down and fasten excessive wire in the re-
cess of the arm.
1. Adjust the distance of the floor counting
contact 61: (if any) and highspeed contact
to 7 mm from the lift well wall.
2. Fasten the highspeed contact magnet (1)
at every floor. Adjust the magnet so it
starts and ends 50 mm from the floor in
question.
To Next Page
Loading...