Device Configuration 5 - 31
Once the configurations of existing Virtual Interfaces have been reviewed, determine whether a new interface requires
creation, or an existing Virtual Interface requires edit or deletion.
6. Select Add to define a new Virtual Interface configuration, Edit to modify the configuration of an existing Virtual Interface
or Delete to permanently remove a selected Virtual Interface.
Figure 5-17 Virtual Interfaces - Basic Configuration tab
The Basic Configuration screen displays by default regardless of a whether a new Virtual Interface is being created or an
existing one is being modified.
7. If creating a new Virtual Interface, use the Name spinner control to define a numeric ID from 1 - 4094.
8. Define the following parameters from within the Properties field:
VLAN Displays the numerical VLAN ID associated with each listed interface.
IP Address Defines whether DHCP was used to obtain the primary IP address used by the Virtual
Interface configuration.
Description Provide or edit a description (up to 64 characters) for the Virtual Interface that helps
differentiate it from others with similar configurations.
Admin Status Either select the Disabled or Enabled radio button to define this interface’s current status
within the network. When set to Enabled, the Virtual Interface is operational and
available. The default value is Disabled.
To Next Page
Loading...
