Motorola WiNG 5.5 - Using the Initial Setup Wizard

3 - 2 WiNG 5.5 Access Point System Reference Guide
3.1 Using the Initial Setup Wizard
 Quick Start
Once the access point is installed and powered on, complete the following steps to get the access point up and running and
access management functions:
1. Point the Web browser to the access point’s IP address. The following login screen displays:
Figure 3-1 Web UI Login screen
2. Enter the default username admin in the Username field.
3. Enter the default password motorola in the Password field.
4. Select the Login button to load the management interface.
5. If this is the first time the access point’s management interface has been accessed, the Initial Setup Wizard automatically
displays.
NOTE: When logging in for the first time, you are prompted to change the password to
enhance device security in subsequent logins.
NOTE: If you get disconnected when running the wizard, you can connect again with the
access point’s actual IP address (once obtained) and resume the wizard.