12 - 16 WiNG 5.5 Access Point System Reference Guide
12.1.6 Adopted Device Upgrades
Devices
To configure an access point upgrade:
1. Select Operations from the main menu.
2. Select Devices.
3. Use the navigation pane on the left to navigate to the device to manage the firmware and configuration files on and select
it.
Figure 12-22 Device Summary screen
4. Select Adopted Device Upgrade tab. The following screen displays:
NOTE: AP upgrades can only be performed by access points in Virtual Controller AP
mode, and cannot be initiated by Standalone APs. Additionally, upgrades can only be
performed on access points of the same model as the Virtual Controller AP.
To Next Page
Loading...
