5 - 160 WiNG 5.5 Access Point System Reference Guide
• Disable Dynamic Chain Selection (radio setting). The default value is enabled. This setting is disabled from the Command
Line Interface (CLI) using the
dynamic-chain-selection command, or, in the UI (refer Radio Override Configuration
on page 5-222.
• Disable A-MPDU Aggregation if the intended vehicular speed is greater than 30 mph. For more information, see Radio
Override Configuration on page 5-222.
5.2.13 Advanced Profile Configuration
System Profile Configuration
An access point profile’s advanced configuration is comprised of defining connected client load balance settings, a MINT
protocol configuration and miscellaneous settings (NAS ID, access point LEDs and RF Domain Manager).
To set an access point profile’s advanced configuration:
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select System Profile from the options on left-hand side of the UI.
4. Expand the Advanced menu item.
The following items are available as advanced access point profile configuration options:
• Advanced Profile Client Load Balancing
• Configuring MINT Protocol
• Advanced Profile Miscellaneous Configuration
To Next Page
Loading...
