Quick Start 3 - 9
3.1.1.2 Standalone Mode
Using the Initial Setup Wizard
In the Standalone mode, the access point is not adopted to a wireless controller. Select this option to deploy this access point
as an autonomous fat access point.
To configure the access point to work in the Standalone mode:
1. From the Access Point Settings screen, select Standalone AP.
2. Select Next.
The remainder of a Standalone AP configuration is the same as a Virtual Controller Access Point.
CAUTION: If designating the access point as a Standalone AP, Motorola Solutions
recommends the access point’s UI be used exclusively to define its device configuration,
and not the CLI. The CLI provides the ability to define more than one profile and the UI
does not. Consequently, the two interfaces cannot be used collectively to manage
profiles without an administrator encountering problems.
!
To Next Page
Loading...
