Motorola WiNG 5.5 - Fault Management

11 - 2 WiNG 5.5 Access Point System Reference Guide
11.1 Fault Management
 Diagnostics
Fault management enables users administering multiple sites to assess device performance and issues effecting the network.
Use the Fault Management screens to view and administrate errors generated by an access point or a connected wireless
client.
To conduct Fault Management on an access point:
1. Select Diagnostics.
2. Select Fault Management.
The Filter Events screen displays by default. Use this screen to configure how events are tracked and managed. By default,
all events are enabled, and an administrator has to turn off events if they don’t require tracking.
Figure 11-1 Fault Management - Filter Events screen
Use the Filter Events screen to create filters for managing events. Events can be filtered based on severity, module received,
source MAC of the event, device MAC of the event and MAC address of the wireless client.
3. Define the following Customize Event Filters:
Severity Set the severity of the event being filtered. Select from the following:
• All Severities – All events are displayed irrespective of their severity
• Critical – Only critical events are displayed
• Error – Only errors are displayed
• Warning – Only warnings are displayed
• Informational – Only informational events are displayed