Device Configuration 5 - 173
7. Define or override the following Shared Configuration setting:
8. Select OK to save the changes made to the environmental sensor screen. Select Reset to revert to the last saved
configuration.
Enable Motion Sensor Select this option to enable the module’s motion sensor. Results are reported back to the
access point’s Environment screens within the Statistics node. This setting is enabled by
default.
Enable Humidity Sensor Select this option to enable the module’s humidity sensor. Results are reported back to the
access point’s Environment screens within the Statistics node. This setting is enabled by
default.
Polling Interval for All
Sensors
Set an interval in either Seconds (1 - 100) or Minutes (1 - 2) for the time between all
environmental polling (both light and environment). The default setting is 5 seconds.
To Next Page
Loading...
