Device Configuration 5 - 201
Figure 5-126 Device Overrides - Adoption screen
7. Define a 64 character maximum Preferred Group.
The preferred group is the controller group the access point would prefer to connect upon adoption.
8. Define the Hello Interval value for this device. This is the interval between hello keep alive messages exchanged with the
wireless controller that has adopted this access point. These messages serve as a connection validation mechanism to keep
the access point adopted to its wireless controller. Set a value from 1-120 seconds.
9. Define the Adjacency Hold Time value for this device. This is the amount of time before the preferred controller group is
considered down and unavailable to provide services. Set a value from 2-600 seconds.
10. Use the spinner control to set the Controller VLAN.
This is the VLAN the Virtual Controller is reachable on. Select from 1 - 4094. There is no default value for this setting.
11. Use the + Add Row button to populate the Controller Hostnames table with the following host, pool and routing
parameters for defining the preferred adoption resource.
Host Use the drop-down menu to specify whether the controller adoption resource is defined
as a (non DNS) IP address or a hostname. Once defined, provide the numerical IP or
hostname. A hostname cannot exceed 64 characters.
Pool Use the spinner controller to set a pool of either 1 or 2. This is the pool the target Virtual
Controller belongs to. The default setting is 1.
Routing Level Use the spinner controller to set the routing level for the Virtual Controller link. The
default setting is 1.
To Next Page
Loading...
