Device Configuration 5 - 339
6. Enable or disable the following Environmental Sensors:
7. Define or override the following Shared Configuration setting:
8. Select OK to save the changes made to the environmental sensor screen. Select Reset to revert to the last saved
configuration.
Low Limit of Light
Threshold
Set the low threshold limit (from 0 - 1,000 lux) to determine whether the lighting is off in
the AP8132’s deployment location. The default is 100.
High Limit of Light
Threshold
Set the upper threshold limit (from 100 - 10,000 lux) to determine whether the lighting is
on in the AP8132’s deployment location. The default is 500.
Enable Temperature
Sensor
Select this option to enable the module’s temperature sensor. Results are reported back
to the access point’s Environment screens within the Statistics node. This setting is
enabled by default.
Enable Motion Sensor Select this option to enable the module’s motion sensor. Results are reported back to the
access point’s Environment screens within the Statistics node. This setting is enabled by
default.
Enable Humidity Sensor Select this option to enable the module’s humidity sensor. Results are reported back to the
access point’s Environment screens within the Statistics node. This setting is enabled by
default.
Polling Interval for All
Sensors
Set an interval in either Seconds (1 - 100) or Minutes (1 - 2) for the time between all
environmental polling (both light and environment). The default setting is 5 seconds.
To Next Page
Loading...
