Quick Start 3 - 7
• Adopted to Controller - Select this option when deploying the access point as a controller managed (Dependent mode)
access point. Selecting this option closes the Initial AP Setup Wizard. An adopted access point obtains its configuration
from a profile stored on its managing controller. Any manual configuration changes are overwritten by the controller upon
reboot. For more information on configuring the access point in the Adopted to Controller mode, see Adopt to a controller
on page 3-35.
4. Select the Country Code where the access point is deployed. Selecting a proper country of operation is a very critical task
while configuring the access point as it defines the correct channels of operations and ensures compliance to the
regulations for the selected country. This field is only available for the Typical Setup Wizard.
5. Select the Next button to start configuring the access point in the selected mode.
NOTE: The option Adopted to Controller is only available for the Advanced Setup
Wizard.
To Next Page
Loading...
