13 - 100 WiNG 5.5 Access Point System Reference Guide
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF Domain and select one of its
connected access points.
3. Select Dot1x from the left-hand side of the UI.
Figure 13-63 Access Point – Dot1x screen
4. Refer to the following Dot1xAuth statistics:
5. Review the following Dot1x Auth Ports utilization information:
AAA Policy Lists the AAA policy currently being utilized for authenticating user requests.
Guest Vlan Control Lists whether guest VLAN control has been allowed (or enabled). This is the VLAN traffic is
bridged on if the port is unauthorized and guest VLAN globally enabled. A green checkmark
designates guest VLAN control as enabled. A red X defines guest VLAN control as disabled.
System Auth Control Lists whether Dot1x authorization is globally enabled for the access point. A green checkmark
designates Dot1x authorization globally enabled. A red X defines Dot1x as globally disabled.
Name Lists the access point ge ports subject to automatic connection and authentication using
Dot1x.
Auth SM Lists the current authentication state of the listed port.
Auth VLAN Lists the virtual interface utilized post authentication.
To Next Page
Loading...
