MR tapcon 230 pro - Page 115

7 Functions and settings
Maschinenfabrik Reinhausen 2014 1153550953/00 EN TAPCON® 230 pro
Function Description
Off No function selected
Master Assign master
Follower Assign follower
ParState Assign parallel operation status
ParError Assign parallel operation error
Local/Rem. Message: Local control/remote
control
Undervoltage Message: Undervoltage blocking
Overvoltage Message: Overvoltage blocking
Undercurrent Message: Undercurrent blocking
Overcurrent Message: Overcurrent blocking
Desired value 1 Message: Desired value 1
Desired value 2 Message: Desired value 2
Desired value 3 Message: Desired value 3
MPS triggered Message: Motor protective switch
was triggered
Motor runtime > Message: Motor runtime exceeded
Motor running Message: Motor running"
Bandwidth < Message: Value fallen below band-
width
Bandwidth > Message: Bandwidth exceeded
GPI 1 Message: GPI 1 active
GPI 2 Message: GPI 2 active
GPI 3 Message: GPI 3 active
GPI 4 Message: GPI 4 active
GPI 5 Message: GPI 5 active
GPI 6 Message: GPI 6 active
GPI 7 Message: GPI 7 active
GPI 8 Message: GPI 8 active
Event Message : Event active
BCD +/- Tap position in BCD code, prefix.
The relay is triggered if the pro-
ceeding sign is negative.
BCD 1 Tap position in BCD code, position
with value of 1.
BCD 2 Tap position in BCD code, position
with value of 2.
BCD 4 Tap position in BCD code, position
with value of 4.
BCD 8 Tap position in BCD code, position
with value of 8.