Descriptions
26
Chain. Selected components remain continually connected to the signal path during
component rotation, A/B comparisons and normal component selection unless changed or
deactivated.
• Speaker Setting – Autosound Speakers tend to pop unless removed from the signal path
during a component change. Therefore, setting the DIP Switch for Speaker causes that
Chain to adhere to the dropout delay parameter set on the MVP Control Module DIP
Switch. For home audio speaker switching, you may set this DIP switch to “component,”
since most home audio Speakers don’t have this problem.
Regardless of the settings of DIP switch #2 and #3, setting a Chain for Speaker
automatically enables the Auto-Rotate feature. It also disables the “Bypass” option.
NOTE: Complete information about DIP switches and their settings is contained in
Appendix A of this manual.
MVP Blank Chain Module
When configuring MVP Control Panel you may want to consider future growth and the need to add more
Dual Chain or Feature Modules. For this purpose, the Blank Chain Module (MVP-BCM), which matches the
dimensions of the Dual Chain Module, reserves space on the display front for future switching requirements.
When the future does arrive, simply remove the Blank Chain Module and install a Dual Chain or Feature
Module into its place.
To Next Page
Loading...
Need help?
General
