Descriptions
36
In order to prevent the accidental activation of multiple on-premise MVP Control Panels, the Infra-Red
Remote Control has a limited range of about twenty-five feet and must be pointed at the MVP Control Panel
to operate. The keys on the Remote may be considered to be in parallel with the same keys on the MVP
Control Module. Whenever the Remote is used, the display on the MVP Control Module will behave
normally as though its own keys were being used.
The Infra-Red Remote uses a single 3V CR 2032 bottom cell lithium battery to operate. A small cover on the
back provides access to the battery compartment. The Operation Section of this manual contains step-by-
step instructions and diagrams for operating the Infra-Red Remote Control.
NOTE: Use caution when storing the Infra-Red Remote Control Unit. If it is placed face down, or has items
stacked on top of it, the buttons may be pressed. This will rapidly drain the batteries and could also
cause unwanted activation of components.
To Next Page
Loading...
Need help?
General
