3-83
3.4 Clear Programmed Data / User Settings
User programmed information such as autodialer entries, date, time, Transmit Terminal Identifier (TTI),
Subscriber ID, etc., are stored in the unit’s Random Access Memory (RAM). A battery back up holes this
information, when the power is lost.
This function does not clear the machine parameters, memory switches and unique switches. Therefore,
this setting is useful to reset the user-programmed information but leave specific parameters and switches
configured for a particular telephone system, etc.
To reset only each switch, see page 3-3, 3-60 and 3-89.
Note: If desired, the All RAM Clear setting can be used to erase all users programmed information, all
documents in memory, and reset the memory switches and machine parameters to factory defaults.
For information on the All RAM Clear setting, see the next page.
1. To clear programmed data and user settings, from standby, press <Menu>, <*>, <0>, <2>.
Clear User Settings
Yes → Enter
2. Press <Enter>.
Note: To finish the operation without performing initialization, press <Cancel>.
To Next Page
Loading...
