Muratec F-315 Field Engineering Manual

3-60
3.3 Memory Switch Adjustment
3.3.1 Setting the Memory Switches
These switches are used to program internal machine parameters. The primary back up battery maintains
these settings if power are lost.
1. From standby, press <Menu>,<*>,<0>,<1>.
Set Memory Switch
/ /Enter
2. Press <Enter>.
3. Call up the desired switch by pressing < > or < >, or by pressing the numeric keypad.
Select Memory Switch
00:00000000
4. Press <Enter>.
01:01010000
00000011
Bit No. 76543210
5. To navigate through the memory switch settings:
• The bits are ranged from 7 (left) to 0 (right).
• Press <
> or < > of the cursor key to move the cursor.
• Press <0> or <1> on the numeric keypad, or <
> or < >, to change the bit value.
• Press <Enter> to save the setting of the displayed memory switch and return to the memory
switch edit screen.
• Press <Reset> not to save the setting of the displayed memory switch.
6. If you want to set other memory switches, repeat step 3–5. Otherwise, proceed to step 7.
7. Press <Reset> to return the machine to standby.
Note: You can confirm the initial setting of each Memory Switch by the Memory Switches List.
The memory switch List will be printed by pressing <Menu>, <*>, <1>, <0>.
3.3.2 Clearing the Memory Switches
Resets the memory switches to factory defaults.
1. From standby, press <Menu>, <*>, <0>, <1>, <
>.
Clear Memory Switch
/ /Enter
2. Press <Enter>.
Clear Memory Switch
Yes → Enter
3. Press <Enter>. The memory switches will reset to factory defaults.
Note: To finish the operation without clearing the memory switches, press <Cancel>.
4. Press <Reset> to return the machine to standby.
About the “
 ” symbol at the list
The “” at the list indicates that you can set the switch respectively for the second phone line. See “3.26
Multi Line Settings” on page 3-146 for the setting.

Muratec F-315 Specifications

General

Brand	Muratec
Model	F-315
Category	All in One Printer
Language	English