Muratec F-315 Field Engineering Manual

3-89
3.7 Unique Switch Adjustment
3.7.1 Setting the Unique Switches
These switches are used to program internal machine parameters. The primary back up battery maintains
these settings if power is lost.
1. From standby, press <Menu>, <*>, <0>, <4>.
Set Uniq Switch
/ /Enter
2. Press <Enter>.
3. Call up the desired switch by pressing < > or < >, or by pressing the numeric keypad.
Select Uniq Switch
00:01010000
4. Press <Enter>.
00:00000000
01010000
5. To navigate through the unique switch settings:
• The bits are ranged from 7 (left) to 0 (right).
• Press <
> or < > of the cursor key to move the cursor.
• Press <0> or <1> on the numeric keypad, or <
> or < >, to change the bit value.
• Press <Enter> to save the setting of the displayed unique switch and return to the unique switch
edit screen.
• Press <Reset> not to save the setting of the displayed unique switch.
6. If you want to set other unique switches, repeat step 3–5. Otherwise, proceed to step 7.
7. Press <Reset> to return the machine to standby.
3.7.2 Clearing the Unique Switches
Resets the unique switches to factory defaults.
1. From standby, press <Menu>, <*>, <0>, <4>, <
>.
Clear Unique Switch
/ /Enter
2. Press <Enter>.
Clear Uniq Switch
Yes → Enter
3. Press <Enter>. The unique switches will reset to factory defaults.
Note: To finish the operation without clearing the unique switches, press <Cancel>.
4. Press <Reset> to return the machine to standby.
About the “
 ” symbol at the list
The “” at the list indicates that you can set the switch respectively for the second phone line. See “3.26
Multi Line Settings” on page 3-146 for the setting.

Muratec F-315 Specifications

General

Brand	Muratec
Model	F-315
Category	All in One Printer
Language	English