3-129
4. Select the paper size to test.
Paper Size :Auto
/ /Enter
Paper Size :A4
/ /Enter
5. Press < > or < > until the desired size is displayed.
6. Press <Enter>.
Pattern B
** Printing **
The selected pattern will be printed continuously.
7. Press <Stop> to stop printing.
8. To select another pattern, repeat the steps 1 to 6.
3.12.3 Feeder test
The feeder test discharges all documents in the automatic document feeder at a constant speed and
displays the document total in the LCD.
1. Load test documents into the automatic document feeder.
2. Press <Menu>, <*>, <0>, <9>, <
> twice, then press <Enter>.
Feeder Test
/ /Enter
3. Press <Start> to start the feeder test.
4. Press <Stop> to exit the test mode.
3.12.4 Port Status
This test mode is not applicable to field service of this machine.
3.12.5 Set Background Level
The background level is an established threshold used to help measure the reflective ability of a scanned
document. This threshold can change if the scanner lamp, CCD, or the ballast is replaced; therefore this
mode should be used to reset the threshold when these items are changed.
The Set Background Level mode allows the level to be set without erasing memory contents.
Note: The background seal at the inside of the scanner cover should be cleaned prior to setting the
background level to ensure an accurate reading.
1. Press <Menu>, <*>, <0>, <9>, <
> four times, then press <Enter>.
Set Background Level
To Next Page
Loading...
Need help?
General
