3-88
Attribute 4 – Individual Autodialer Setting (Equivalent to Memory Switch 13)
Switch
Initial
Setting
Adjust Usage/Comments
7 0 ANSam detection
0: Yes
1: No
During the V8 handshake, if some noise disturbs
the handshake and an error occurs, set to “1”.
6 0 V.34 transmission
0: Yes
1: No
Individual setting for V.34 transmission.
5 0 Factory use only
4 0 ECM mode
0: On
1: Off
Determines ECM mode. ECM mode reduces
document memory and may lengthen transmission
and reception times.
3 0 Retransmit automatically
when receiving RTN/PIN
signals
0: Yes
1: No
When set to “1”, retransmission disables
automatically if receiving RTN/PIN signals.
2 1 Factory use only
1 0 Factory use only
0 0 Factory use only
To Next Page
Loading...
Need help?
General
