Handling the printer RJ-900X series OPERATION MANUAL
4-22
Stiffness <Normal> Depending on the stiffness of media, the power to
absorb media to the printing board is set.
• Normal: Set when general media is used.
• Soft: Set when soft media is used and it fails to feed
media during printing and there is likely to be media
jams.
• SuperSoft: Set when softer media is used and there
is likely to be media jams in "Soft" setting.
• •Frame: Set when media which has a frame for
reinforcement is used.
Soft
SuperSoft
Frame
InkDryTimer <0 s> to 270 s to 60 m The discharge of color ink during printing is adjusted to
the media quality.
RollCut <On> Sets whether to cut the media after printing.
• ON: Automatically cuts the media after printing.
• OFF: The media is not cut after printing.
Off
CutMethod <2steps -Lo>*
1
Sets the media cut method when using the roll media.
• 2steps : Cuts the media twice.
• Hi/Lo : Changes the strength of cutting the media.
• 3steps : Cuts the media three times.
• Hi/Lo : Changes the strength of cutting the media.
*1:Default values differ depending on the media.
• Glossy paper : 2steps -Hi
• Other media : 2steps -Lo
<2steps -Hi>*
1
3steps -Lo
3steps -Hi
PF Initial Print Based on the printed adjustment patterns, enter the
length and measured distance of the data as the set
values.
4.5.1.2.3 Media Feed Compensation Menu
Initial Change
Confirm Print
Micro Print
Micro Change
AdjustPrint Pattern A Performs accuracy adjustment printing or adjusted
value initialization.
4.5.1.2.4 Adjust Print
4.5.1.2.5 Initializing Adjust Print
Pattern B
Pattern C
Initial
Setup item Setting value Description
To Next Page
Loading...
Need help?
General