Before using RJ-900X series OPERATION MANUAL
3-8
3.3 Installing ink cartridges
This sub-section describes the replacement time and steps of ink cartridges.
• While handling ink cartridge, pay attention so that the ink does not get into eyes or stick to
the skin. If the ink gets into the eyes or sticks to the skin, immediately wash off with water.
It might possibly cause irritation and light inflammation of eyes. In case of any abnormality,
consult the physician immediately.
• Do not disassemble the ink cartridge. If disassembled, there is a possibility that the ink
might come into contact with eyes or skin.
• When filling up with ink, use the ink cartridge of original manufacturer product.
This printer has been adjusted for use of genuine ink cartridges. In case of using ink cartridge which
is not a product of the original manufacturer,
• Printing might become blurred and end of ink in the cartridge might no longer be correctly
detected.
• The problems caused by doing so will not be covered by the warranty and repair expenses will
be paid by the customer.
•
Refer to the following for types and details of ink cartridges.
7.3 Options/Supply list
• Do not give ink cartridges strong shake. Doing so may cause ink leakage.
• Do not disassemble the ink cartridge. A disassembled ink cartridge cannot be used.
• When the ink cartridge is moved from a cold place to a warm place, keep the ink cartridge unused
for three hours or more in the printing environment.
Install the ink cartridge as shown in the following procedure.
1. Turn ON the power of the printer.
To Next Page
Loading...
Need help?
General