Maintenance RJ-900X series OPERATION MANUAL
5-10
5.1.3 Replacing razor blade
This sub-section describes the replacement time and steps of razor blade.
（1）Replacement time
Replace the razor blade when the following situation occurs.
a. If the media cannot be clearly cut.
Failure in cutting media displays "Paper Cut Error" on the operation panel.
b. If fuzz, etc. appears on the cut section
（2）Type
Our genuine razor blade that can be used for the prrnter is as follows.
（3）Replacing steps
Replace razor blade according to the following steps.
1.
Check that the power to the printer is turned ON.
3.2.1 Turning the power ON
2. Press the [Menu] key on the operation panel to display the setup menu.
• Operation panel shifts to the Setup menu display.
Description Model No.
Substitute razor blade RJ3-CBS
To Next Page
Loading...
Need help?
General