RJ-900X series OPERATION MANUAL Before using
3-25
3.4.4 Releasing the Partial Function of Pressure Arms
If thin media is creased while printing, release some of Pressure arms.This may prevent getting creases.
Follow the procedure below to release Pressure arms.
1. Raise Media loading lever.
2. Push the release switches of Pressure arms further in that are holding the sides of the media.
• When the release switch is set further in, Pressure arms lose the pressure.
No. Name
1
Media loading lever
No. Name
1
Pressure arms
2
Release switch
To Next Page
Loading...
Need help?
General