Maintenance RJ-900X series OPERATION MANUAL
5-28
5.2.4 Cleaning Cleaning Wiper
This section describes how to clean Cleaning wiper.
（1）Time for cleaning
Once a week, or when blurs or lacking parts appear on printed media after Head cleaning.
（2）Cleaning procedures
Follow the procedure below to clean Cleaning wiper.
• Use a non-woven cloth (commercial product) to clean Cleaning wiper.
Other material of cloth may clog Print head; make sure to use a non-woven cloth.
1. Check that the printer is turned ON.
3.2.1 Turning the power ON
2. Press the [Menu] key on Operation panel.
• Operation panel shifts to the Setup menu display.
To Next Page
Loading...
Need help?
General