RJ-900X series OPERATION MANUAL Before using
3-39
3.6.5 Setting IP Address
Make IP address settings on the printer side.
Follow the procedure below to set the IP address.
1. Check that the printer is turned ON.
3.2.1 Turning the power ON
2. Press the [Menu] key on Operation panel to change the display to the Setting menu.
• "*Menu* Test Print>" is displayed on Operation panel.
3. Press the [<] key or [>] key on Operation panel to display the Network menu.
• "*Menu* Network>" is displayed on Operation panel.
• For the key operation while the Setting menu is being displayed, refer to 4.5.2 Menu Setup Procedure.
4. Press the [Enter] key on Operation panel to display the IP address menu.
• "Network: IP Address>" is displayed on Operation panel.
To Next Page
Loading...
Need help?
General