RJ-900X series OPERATION MANUAL Handling the printer
4-49
4.5.1.8.7 Spitting Pass Count Menu
Set the intervals that Print head returns to Spitting boxes when “On” or “On Media” is set in Spitting
menu.Print head returns to Spitting box for every shuttle per the set number.
• If the number of spitting returns is set high, the spitting operation is not done on Spitting box.
Therefore there is a higher chance of nozzle clogging when printing for a long time.In such a case,
print quality cannot be guaranteed.
4.5.1.9 Consumption Menu
Utilization status of printer components is displayed.
Take it into consideration for the component replacement.
• Do not take out or insert ink cartridge while the printer is turned ON. If doing so, the ink residual
quantity is not correctly detected and the printing cannot be done.
• Do not keep using the parts which have reached the lifespan without changing. The problems
caused by doing so will not be covered by the warranty.
• For the operation of the setting menu, refer to “
4.5.2 Menu Setup Procedure”.
Setup item Setting value Description
ReturnCount <1 time> to 999 times Set the spitting return count.
Setup item Setting value Description
Remain Ink K
0 ～ 100%
Residual quantity of each color is displayed.
"Ink End" error is displayed at 0 %.
Remain Ink C
0 ～ 100%
Remain Ink M
0 ～ 100%
Remain Ink Y
0 ～ 100%
Remain Roll **m Residual quantity of roll media is displayed.
It is displayed when it is set on roll media management
menu.
RemainWasteTank
0 ～ 100%
Residual quantity in waste tank is displayed.
Waste fluid quantity in the box becomes full at 0 %.
RemainCutterLif.
0 ～ 100%
The life of cutter is displayed.
The lifespan of the parts is reached at 0 %.
To Next Page
Loading...
Need help?
General